Elmes 300 Ton 4 Post Downstroke Hydraulic Press

Description:

Used Elmes Hydraulic Press with:

• Approximate speeds:
  • Closing: 900 inches per minute
  • Pressing to 115 tons: 320 inches per minute
  • Pressing to 300 tons: 140 inches per minute
  • Return to 45 tons gross: 900 inches per minute
• Power units:
  • (2) Vickers PV-2080-FHAB piston pumps
  • Variable volume
  • 77 Gallons per minute @ 2500 psi each
  • Each driven by 75 horsepower, 1175 rpm, D.E. motor
• Single action with 100 ton bydraulic bed cushion
• Distance between square guide posts:
• Width: 72 inches
• Depth: 27 inches
• Nominal bed area (inches): 72 wide x 48 deep
• Area of bed bolster (inches): 72 wide x 46 deep x 6 thick
• Nominal area of slide (inches): 65 wide x 41.5 deep
• Area of cushion platen (inches) : 59 wide x (approx) 31 deep
• Maximum stroke of gib guided slide: 24 inches
• Maximum daylight opening over bolster: 36 inches
• Maximum stroke of gib guided cushion: 10 inches
• Main ram diameter (1): 16.5 inches w/9.5 diameter internal ram @ 2370 psi - 253.5 tons
• Side ram diameter (2): 5 inches diameter @ 2370 psi - 46.5 tons
• Pullback ram diameter (2): 5 inches diameter @ 2290 psi - 45 tons
• Cushion ram diameter (1): 11.5 inches w/7 inch diameter internal ram @ 1925 psi - 100 tons
• Floor to top of bolster: 38.5 inches
• Controls:
  • Pushbutton operation w/stroke & pressure controls
  • Dual operator palm buttons
• Approximate overall dimensions (feet): 16 wide x 7 deep x 18 high (above floor)
• Custion extends approximately 5 feet below press feet